They were used between early 1942 to sometime in 1944. Style 2C plates were made of 'oilboard' (dense coated cardboard) and measured 3/4' x 3' with rivet holes spaced the same as the first style plates. Style 2B plates were made of steel, appeared in 1942, and are quite rare. It is likely that the plate shown above originally had a red background. We have seen two other examples of a brass plate, one of which has red-painted background and the other has traces of red paint remaining. Style 2A plates were made of brass plate and are from late 1941 or early '42. Style 2 plates are from the World War II era, and are made from one of three materials: brass, steel or oilboard.

This style was used beginning circa 1939-1940 to sometime in 1942 (probably early 1942), and then again from sometime in 1944 to late 1947.

Style 1 plates were made of aluminum and measured 1/2' X 3' with rivet holes approximately 2 3/4' on center. We have divided the serial number plates used by Delta into three styles, as detailed below. If your machine lacks a serial number plate or holes to mount one then it is from early 1941 or before. The easiest way to vintage a Delta machine is of course with the serial number. At the very least you will be able to establish date While trying to vintage an old machine isn't rocket science it does require a certain bit of savvy. Please read it carefully as there are subtle nuances and It contains the most rudimentary data required to start one's career dating Delta. This write up will act as the jumping off point for anyone wanting to vintage an old Delta machine or for someone wanting to submit content on a machine of aĬertain vintage. You are the strong type, not easily duped, please move along. This introductory article you will be hunting down the true meaning of Delta and becoming obsessed with *Born On Dates* and *vintaging* Delta on the fly. If you are of the type who easily follows shamans or gets fooled into get rich schemes you are the one I'm looking for. '1234-A' and other formats not shown here): Note: if you're looking for serial numbers from a 20' Bandsaw or other machine made by / with Crescent, look here (e.g. Straight Numerical Series used by Milwaukee-CrescentĪlpha-Numeric Series Used By Tupelo Division:

Reading milwaukee date code